|
On a unfaired bike like the GS, even a well
designed windscreen provides, at best, just minimal protection for a driver and
passenger. That's why we design Half Fairings for the GS's. In our
opinion, the Half Fairing design is the only way to create an envelope of
protection for a driver, or 2-up, that provides an unequalled level of comfort.
Our Half Fairing offers over the helmet airflow with no turbulence, no buffeting
and no back pressure. Protection you can't attain with just a windscreen.
2008 R1200GS Models
●Our
Half Fairing will not mount on the 2008 GS model without some modifications.
We have determined the changes that need to be made and hope to have an 2008
version out by August.
Upper Windscreen Portion
●The
Upper Windscreen portion allows airflow to the backside of the windscreen.
This airflow combines with the air traveling on the front of the screen at the "flare" or "lip", pushing the air up and over your helmet.
●Upper
Windscreen portion available in 4 heights: Standard, Medium, Tall & Extra Tall.
●Heights measured vertically from top, front edge of gas tank.
Standard: Only for drivers up to 5'7 with low seat.
Medium: 17 3/8" - For drivers up to 5'11"
Tall: 19 5/8" - For drivers up to 6'3"
X-Tall: 21 1/4" - For drivers 6'4" and up
●Upper
Windscreen width, measured horizontally with yard stick.
Width at widest point: 20"
Width at top: 14"
Half Fairing Body Portion
●Directs air down, out and away from the rider. The Fairing
Body delivers
lower torso protection and expands the envelope of protection.
●Fairing
Body available in Clear or Smoke. Clear Body is paintable to match your
bike, simply spray the backside of the Body with spray paint made for plastics.
●Fairing
Body width, measured horizontally with yard stick.
Width at widest point: 24 1/2"
Steel Mounting Brackets
●Brackets
are Powder Coated Steel. Stainless Steel and Nylon mounting hardware.
Non US R1200GS Models
●Non
US R1200GS models require longer turn signal stalks to fit thru
the opening in Fairing Body. The turn signal stalks are available thru
A&S BMW, for approximately $15 each,
the part numbers are listed below. You will also need to extend the wiring
for each turn signal by 2".
BMW Part Number: (Qty 2) "Turn Indicator Holder, Front #63137667768"
|
Not Just Windscreens... We Offer Solutions.
